Rules
Repeaters
- Tepeximilpa, Mexico City, 438.025 MHz, -5.0 MHz, DPL 432 for FM analog voice, BW 25 KHz. Motorola MTR 2000, 40 Watts, 120 Ah power backup.
- Tepeximilpa, Mexico City 147.390 MHz +600 KHz NAC $293 for P25 Phase 1 voice and data, 167.9 Hz for analog voice, BW 25 KHz. Motorola Quantar 25 Watts, 12 Ah power backup.
- Benito Juárez, Mexico City, 438.050 MHz, -5.0 MHz, DMR CC 1, BW 12.5 KHz, Motorola SLR5100 10 Watts, no power backup.
- Benito Juárez, Mexico City, down-link 146.550 MHz, up-link 433.550 MHz, TPL 167.9 for FM analog voice, 10 Watts, 120 Ah power backup. Itinerant cross band repeater using two mobile radios.
- Altzomoni, Mexico City, 147.240 MHz, +600 KHz, 103.5 Hz for analog voice, DMR CC 1, Fusion DCS 00, BW 25 KHz. Yaesu DR-1X 20 Watts, no power backup. This repeater is hosted and supported by Heliott Zayas.
PTTLink nodes
- PTTLink Node 43852 P25Link Talk Group 2050.
- PTTLink Node 51410 Benito Juárez, Mexico City, 146.400 MHz, 0.0 KHz, TPL 167.9 Hz.
- PTTLink Node 51467 Benito Juárez, Mexico City, Experimental.
Echolink nodes
- None, as I don’t like appliance operators.
IRLP nodes
- IRLP Node 5334 Tepeximilpa, Mexico City, 438.025 MHz, -5.0 MHz, DPL 023, BW 25 KHz.
- IRLP Node 5995 Benito Juárez, Mexico City, 433.650 MHz, TPL 167.9 Hz, BW 25 KHz.
- IRLP Node 5882 Taxqueña, Mexico City, 433.750 MHz, TPL 167.9 Hz, BW 25 KHz.
Motorola Wave
- Astro-P25 Talk Group, bridged to P25Link network.
HamWAN
Currently on the market to start setting up a state wide network. Expected to be ready by March 2022.
My stuff, my rules
Here you will find the rules and policies for using my repeaters, bridges and nodes. If you do not follow them, you will be blacklisted. That simple.
As the owner, I reserve the right to forbid the use of any repeaters, bridges, remote bases or voice over internet protocol by anyone who repeatedly violates these rules, or anyone who facilitates or encourages others to violate these rules.
Calling another station format
A user should call another user using the - "called unit from calling unit" format (also known as "hey you - it´s me" format) using calling identifiers as shown above:
- “Illinois State Police car 2-5 From IMEA 3”
Followed by:
- “IMEA 3 From Illinois State Police car 2-5, go ahead”
Rules
Legal
My repeaters, bridges and nodes maintain and operates high-quality, wide-coverage area for the use of all amateur radio operators. Operation and use of these shall comply fully with:
- US Amateur Radio Service (Part 97) regulations of the Federal Communication's Private Radio Service.
- Mexico IFT Ley Federal de Telecomuncaciones y Radiodifusión published on July 14, 2014.
Operational
- My repeaters, bridges and nodes are provided for the purposes of contacting and passing information between fellow amateur radio operators, and providing service to the public as a voluntary, non-commercial communication service, research and development, and particularly with respect to providing emergency communications when comercial services are not available. If you can reach 911 go that way.
- In the spirit of Amateur Radio Service, users shall respect and support each other in a courteous and positive manner. Due to the wide coverage of the repeater system operators should always pause a minimum of three seconds before transmitting, to allow another station to break in.
- Due to the number of repeaters and/or nodes on-line, key your microphone two seconds before talking to let those systems start.
- Operators shall announce their call sign before transmitting any touch-tone commands, at the end of each communication, and every ten minutes or less during a communication.
- There shall be absolutely no communications containing obscene, indecent, or profane words, language, or meaning. Discussion of religion, political or potentially sensitive social issues shall be avoided.
- For digital systems as DMR, NXDN and P25, you must have your 7-digit ID will be according to the DMR-MARC/TRBO-6/NorCal/DCI/NC-PRN scheme. [You can apply here].
- Be sure also to DISABLE the ARS!!! ARS is not permitted on DMR. We do not allow GPS positions to be beaconed over the ENTIRE network every 30 seconds.
- For digital repeaters, see my Talk Groups list. Using not listed Talk Groups is forbidden.
- For DMR-MARC talk groups you must also follow the DMR-MARC rules.
- For DMR+ talk groups you must also follow the DMR+ rules.
- No one shall cause or condone the malicious or intentional interference of anyone's communications on the repeaters, bridges or nodes.
- Users shall not communicate with, or discuss the actions of, anyone who violates these rules.
I will turn off a repeater, bridge or node to terminate improper operation. No warnings or explanations, you are supposed to know the rules if you are using my systems.
- Control of node connections is normally restricted. Visitors should e-mail me (km4nno at yahoo.com) to gain access codes for the phone patch, PTTLink, IRLP or Echolink nodes they want to connect to other reflectors or nodes. The gateway to the reflectors is open to hams to talk to whoever they hear.
- Some IDs, nodes and experimental reflectors are black-listed, please do not contact me to white-list them. I will never do. Their owners/admins been rude with me with no reason, those are the consequences.
- If your node is connected to one of my nodes, there must be NO (as in zero) repeater hang time allowed to pass through to PTTLink, IRLP, or Echolink, nor anything resembling a courtesy tone. This means set it to zero, not 500ms or even 100ms. If you are using a keyed CTCSS approach to solving this problem, make sure your tone encoder/decoder combination drops as fast as possible. No repeater IDs or controller messages are allowed at all, unless they are under a user transmission.
- Cross-links are only acceptable with a written permission from me. Please contact me before making any test or connection or you will be black-listed forever.
- Please advise your users to disconnect your node if a local conversation becomes extended. Short local greetings are okay while connected, but do not tie up my nodes with a 10 minute local QSO or worst, one hour.
Always use High Power on portables
Use High Power in portables. Mexico City is not a flat field with no obstructions. Spend some money on batteries and do not live trying to save your only battery, that only keep you making noise on my repeaters. If even with High Power you can not reach my repeaters or nodes, try a better location, a better antenna and/or a better radio, Baofengs are crap!
Support and donations
Sorry, no support. I will not help you to program your radio or setup your system, there is plenty information in libraries, books, and on the Internet. Learn yourself. Yes this is the way I was taught by old amateur radio farts, now is time to pay them back.
I do not accept any help, contributions, donations, etc. When people makes any of these, they thinking they are the new owners of my stuff, They want to rule and take decisions and control over it, so forget about it. Invest on your own.