Mo-Sys StarTracker

From WLPS Wiki
Revision as of 17:41, 25 March 2021 by Wodie (talk | contribs) (→‎Input)
Jump to navigation Jump to search

Main

Alg

Calib

Mapping

Data

Output

  • Sync Type - Select your GenLock Input signal, Black Burst, TriSync and SDI are accepted, but in SD format, HD is NOT SUPPORTED.
  • Test Data - Select diferent test patters of data set via network.
  • F4 Lens - Turn On if using DigiLens, this option also shows in Lens Data sub menu.
  • Encoder Lens Input only shows which lens encoder is selected on Input sub menu.
  • Serial Out - Enables MoSys serial output if not using ethernet option.

Unicast

  • Destination IP 1, 2, 3 - Set the input to send unicast UDP data.
  • Port 1, 2, 3 - Selects the UDP port number.
  • Protocol 1, 2, 3 - Select the protocol to be sent to each unicast address.
  • Send UDP 1, 2, 3 - Enable/Disable the unicast data output.
  • Ping 1, 2, 3 - send a ping to a Destination Address.

Broadcast

  • BC Port - Selects the UDP broadcast port number.
  • BC Protocol - Select the protocol to be sent to the broadcast address.
  • Broadcast - Enable/Disable the broadcast data output.
800x600
800x600

Input

  • Via Serial Lens - Select the input mode for lens data (Focus & Zoom).
STM - External MoSys encoders.
  • Serial Log - open a console log window.
  • Via UDP - Enable/Disable UDP data input.
  • UDP Port - Select the input UDP port.
  • 4 Axes -
  • Fuse Enc -
  • Enc Only -
800x600
800x600

Record

800x600
800x600

Lens Data

  • Enable - Turn On if using DigiLens.
  • Type - Select Wheels if using external encoders.
  • Load File - Only apply for Digilens.
  • Extender - Loads the Extender Menu.
For external encoders, only set the extender X factor.
Load Lens file only for DigiLens.
  • Reverse Encoders - Invert the encoders direction for Focus or Zoom.
  • Reverse Lens File - Invert the encoders direction for DigiLens Focus or Zoom.
800x600
800x600

Network

800x600
800x600

Advanced

  • F4 Status - On to send data to D3.
  • F4 ST ID - On to be read properly on D3.
  • Serial IO - Must be On for Gen Lock and Lens Encoders.
  • Use IMU - Need to be on, so IR camera works.
800x600
800x600

Tunning