Mo-Sys StarTracker: Difference between revisions

From WLPS Wiki
Jump to navigation Jump to search
Line 38: Line 38:
* BC Protocol - Select the protocol to be sent to the broadcast address.
* BC Protocol - Select the protocol to be sent to the broadcast address.


* Broadcast -  Enable/Disable the bradcast data output.
* Broadcast -  Enable/Disable the broadcast data output.


[[File:data_output.jpeg|none|800x600]]
[[File:data_output.jpeg|none|800x600]]

Revision as of 17:37, 25 March 2021

Main

Alg

Calib

Mapping

Data

Output

  • Sync Type - Select your GenLock Input signal, Black Burst, TriSync and SDI are accepted, but in SD format, HD is NOT SUPPORTED.
  • Test Data - Select diferent test patters of data set via network.
  • F4 Lens - Turn On if using DigiLens, this option also shows in Lens Data sub menu.
  • Encoder Lens Input only shows which lens encoder is selected on Input sub menu.
  • Serial Out - Enables MoSys serial output if not using ethernet option.

Unicast

  • Destination IP 1, 2, 3 - Set the input to send unicast UDP data.
  • Port 1, 2, 3 - Selects the UDP port number.
  • Protocol 1, 2, 3 - Select the protocol to be sent to each unicast address.
  • Send UDP 1, 2, 3 - Enable/Disable the unicast data output.
  • Ping 1, 2, 3 - send a ping to a Destination Address.

Broadcast

  • BC Port - Selects the UDP broadcast port number.
  • BC Protocol - Select the protocol to be sent to the broadcast address.
  • Broadcast - Enable/Disable the broadcast data output.
800x600
800x600

Input

800x600
800x600

Record

800x600
800x600

Lens Data

  • Enable - Turn On if using DigiLens.
  • Type - Select Wheels if using external encoders.
  • Load File - Only apply for Digilens.
  • Extender - Loads the Extender Menu.
For external encoders, only set the extender X factor.
Load Lens file only for DigiLens.
  • Reverse Encoders - Invert the encoders direction for Focus or Zoom.
  • Reverse Lens File - Invert the encoders direction for DigiLens Focus or Zoom.
800x600
800x600

Network

800x600
800x600

Advanced

  • F4 Status - On to send data to D3.
  • F4 ST ID - On to be read properly on D3.
  • Serial IO - Must be On for Gen Lock and Lens Encoders.
  • Use IMU - Need to be on, so IR camera works.
800x600
800x600

Tunning