Mo-Sys StarTracker

Data

Output

800x600

• Sync Type - Select your GenLock Input signal, Black Burst, TriSync and SDI are accepted, but in SD format, HD is NOT SUPPORTED.

• Test Data - Select diferent test patters of data set via network.

• F4 Lens - Turn On if using DigiLens, this option also shows in Lens Data sub menu.

• Encoder Lens Input only shows which lens encoder is selected on Input sub menu.

• Serial Out - Enables MoSys serial output if not using ethernet option.

Unicast

• Destination IP 1, 2, 3 - Set the input to send unicast UDP data.

• Port 1, 2, 3 - Selects the UDP port number.

• Protocol 1, 2, 3 - Select the protocol to be sent to each unicast address.

• Send UDP 1, 2, 3 - Enable/Disable the unicast data output.

• Ping 1, 2, 3 - send a ping to a Destination Address.

Broadcast

• BC Port - Selects the UDP broadcast port number.

• BC Protocol - Select the protocol to be sent to the broadcast address.

• Broadcast - Enable/Disable the bradcast data output.

Input

800x600

Record

800x600

Lens Data

• Enable - Turn On if using DigiLens.

• Type - Select Wheels if using external encoders.

• Load File - Only apply for Digilens.

• Extender - Loads the Extender Menu.

For external encoders, only set the extender X factor.

Load Lens file only for DigiLens.

• Reverse Encoders - Invert the encoders direction for Focus or Zoom.

• Reverse Lens File - Invert the encoders direction for DigiLens Focus or Zoom.

800x600

Network

800x600

Advanced

• F4 Status - On to send data to D3.

• F4 ST ID - On to be read properly on D3.

• Serial IO - Must be On for Gen Lock and Lens Encoders.

• Use IMU - Need to be on, so IR camera works.

800x600