Search results

...you can log in with a keyboard and monitor or using SSH as in the initial node setup. == Allmon2 Configuration. == ...

...our nodes call sign (means on the AllSTarLink website, not on the physical node), tick the check box that says 'Check this box to change all your callsigns Next, click on '''<Portal>''' and then click on '''<Node Settings>''' ...

== User configuration == Edit the config file with your callsign and node settings. ...

* [[LED screens]] - Configuration notes and passwords. * [[Mo-Sys StarTracker]] - Configuration screenshots. ...

...e image files for you computer system you will use to run your AllStarLink node. == Request a Node number == ...

...orwarding > Add Rule and forward port 443 Protocol TCP to your AllStarLink node Raspberry Pi IP address. # For most configuration files from conf-available/, which are ...

...llowing information is originally from [http://docs.allstarlink.org/drupal/node/12 echolink.conf]. ...d dial *3 followed by 3123456. As you can see we have reserved AllStarLink node numbers with a leading 3 for the Echolink number space. ...

...ne of the image files for you computer system you will use to run your ASL node. == Request a Node number == ...

Selecciona la opción '''AllStarLink Configuration Edit Menu''' En Node el número del nodo que configuraste en la sección anterior. ...

The Radio Thin Client Module (RTCM) is [http://www.micro-node.com/thin-m1.shtml commercially available] hardware for interfacing radios t The Micro-Node RTCM (and [[VOTER-Hardware | VOTER]]) interfaces are typically used with Al ...

*[[VOTER-Audio | Audio Interfacing and Configuration]] *[[VOTER-GPS | GPS Interfacing and Configuration]] ...

...voter.conf</code> file, each stanza (category/instance) is named by the '''node number''' that the clients specified within the stanza are to be associated ...Voter/1999'' in <code>rpt.conf</code>) and is directly associated with the node that opened it. ...

= Repeater Configuration = = AllStarLink Configuration = ...

* 01 Micro-Node RTCM board. * 01 Micro-Node RTCM board. ...

.../code> file is generally going to be located with the rest of the Asterisk configuration files, in <code>/etc/asterisk</code>. ...pical voting repeater scenario, the ''instance'' would typically be the '''node number''', and all the clients would be the transmitter client and all the ...

.../code> file is generally going to be located with the rest of the Asterisk configuration files, in <code>/etc/asterisk</code>. ...pical voting repeater scenario, the ''instance'' would typically be the '''node number''', and all the clients would be the transmitter client and all the ...

= Micro-Node RTCM Clock Issue = ...cted a small run of the RTCM's. The issue was eventually resolved by Micro-Node, but we'll document it here just for record keeping. ...

...repeater/node coverage you only need a TETRA radio. I there is no repeater/node in your area you can setup one an link it to the TETRA Mexico network. * GPS>LIP Configuration/Destination ISSI = 9999 ...

...o a Motorola Quantar (Quantro should be similar). These are just the basic configuration steps, based on the following scenario: ...m/motorola/quantar/qim/part-14-station-configuration.pdf Part 14 - Station Configuration], you will find a section called "Fast Keyup Feature". ...

Hasta arriba de la página, da click en '''<Portal>''' y luego en '''<Node Settings>'''. [[File:Ptt site node settings.png|none|thumb|604x604px]] ...